List of All Grbl Error and Alarm Codes and a description of why you might see them
Author Archives: 3dtekadmin
These are the quickest most foolproof steps to take in updating GRBL onto an Atmel based board like Arduino, the GRBL-AIO and others – basically, any board that runs GRBL will be updatable following this guide.
3Detk.xyz have now replaced or supplied replacement electronics for around 100+ 3020, 6040, and other Chinese routers with Dead on Arrival (DOA) Electronics.
It does not appear to be slowing down and so instead of helping on a one on one basis, we will now write up each repair/replacement so that eventually we have a list of the issues and fixes for each of the models.
Bobs 3020: Seems the warranty didn’t ship with this one and the 100% satisfaction was also missing
PhotoVCarve does not seem to have the grbl post processor by default. There is a solution posted here in the Vectric forum.
Unimig/Jasic has fitted a CNC interface to their lineup of plasma units.
This is great news however it’s so new that it’s not yet documented.
Last week Hind Technology and 3DTek.xyz collaborated to donate and commission 3DTek’s Heavy Mill powered by Hind Technology’s Masso controller at MakerSpace&Co in Marrickville.
GRBL – Testing limit switches.
Setting up the PI9000 VFD’s
Wiring: …
Programming Important Parameters: …
NOTE: This CNC shield product has been superseded by the GRBL Breakout and or GRBL AIO How to setup the Alternate CNCShield 4 Driver electronics board. Note, stepper driver chips are fragile and may be damaged by applying power without a motor connected — always wire things up completely, and verify all connections each time before […]